We currently have a Site to Site VPN between three different locations
running Check Point R55.
I'm conducting a test for R60 by creating an Externally Managed Check
Point Gateway for a Site to Site VPN (Mesh VPN Community), the following
message appeared:
You have chosen the "main IP" method of IP selection for VPN Link
Selection. However, this gateway's main IP is not a member of Topology
table. Under this configuration Link select will not be functional.
Is anyone able to setup a site to site VPN successful between R55 and
R60 using manual SHARED SECRET?
Sam Nimjareansuk
This message contains confidential information and is intended only for
fw-1-mailinglist AT us.checkpoint DOT com. If you are not the named addressee
you should not disseminate, distribute or copy this e-mail. Please notify the
sender immediately if you have received this e-mail by mistake and please
delete this e-mail from your system. Finally, the recipient should check this
email and any attachments for the presence of viruses. Bond Beebe Advisors &
Accountants accepts no liability for any damage caused by any virus transmitted
by this email. 23/10/2006
Bond Beebe Advisors & Accountants, 4600 East-West Highway, Suite# 900,
Bethesda, MD, 20814-3423, US, www.bbcpa.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
