The issue you have is not related with the fact that you have R55 and R60 on
both ends, nor that you are using shared-secret.
First make sure the main IP address you have on the gateway object
(properties > general tab) is in fact one of the IPs configured on the
machine NICs and if it is and it is not the external one, or at least the
one you are using to establish the VPN with the other gateway, go to the the
Link seleccion options of the gateway object (properties >Link Selection)
and change the "main IP" method for something different.
For more info about Link Selection, check out the VPN pdf document for NGX.
Regards
On 10/23/06, Sam Nimjareansuk <Sam AT bbcpa DOT com> wrote:
We currently have a Site to Site VPN between three different locations
running Check Point R55.
I'm conducting a test for R60 by creating an Externally Managed Check
Point Gateway for a Site to Site VPN (Mesh VPN Community), the following
message appeared:
You have chosen the "main IP" method of IP selection for VPN Link
Selection. However, this gateway's main IP is not a member of Topology
table. Under this configuration Link select will not be functional.
Is anyone able to setup a site to site VPN successful between R55 and
R60 using manual SHARED SECRET?
Sam Nimjareansuk
This message contains confidential information and is intended only for
fw-1-mailinglist AT us.checkpoint DOT com. If you are not the named addressee
you
should not disseminate, distribute or copy this e-mail. Please notify the
sender immediately if you have received this e-mail by mistake and please
delete this e-mail from your system. Finally, the recipient should check
this email and any attachments for the presence of viruses. Bond Beebe
Advisors & Accountants accepts no liability for any damage caused by any
virus transmitted by this email. 23/10/2006
Bond Beebe Advisors & Accountants, 4600 East-West Highway, Suite# 900,
Bethesda, MD, 20814-3423, US, www.bbcpa.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
--
Sergio Alvarez
(506)8301342
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
