I had a similar issue just upgrading from R60 HFA3 to HFA4 on the
SmartCenter itself. In my case I just ran cprid start on my firewalls
and everything was good again.
Jeremy Lieb CCSE-NG CCSE+NG
Firewall Administrator
Open Text Corporation
100 Tri-State Int'l Pkwy
Third Floor
Lincolnshire, IL 60069
18472679330 ext 4395
-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Fred
Katsumi
Sent: Wednesday, November 22, 2006 2:17 PM
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: Re: [FW-1] Upgrade to R61 or R62?
Hi all,
Just an update. I went ahead and upgraded the smartcenter from R60 to
62. That went pretty smoothly. But after the upgrade I kept getting a
communication error between one of the firewalls (R60) and the new
SmartUpdate when I tried to Get Gateway Data or Pre-Install Verifier.
The error was:
Unable to connect. Make sure that: the network connection is up, trust
is established, and cprid connections are allowed
SIC was fine and I could still push the policy. Checked to make sure
CPRIP is running and even reset SIC. I ended up uninstalling R60,
cleaning it and rebuilding the gateway as R62, which is not a big deal.
Now everything looks to be in order.
Fred
----- Original Message -----
From: Mailing list for discussion of Firewall-1
=================================================
To set vacation, Out-Of-Office, or away messages, send an email to
LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your subscription options,
email fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
