Same
-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Garner,
Annette K **BETH
Sent: Wednesday, January 31, 2007 4:49 PM
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: Re: [FW-1] NICS AND PROVENTIA G400'S
What version of firmware are you running. I am currently running
firmware 1.2 on our Proventia G400's.
Thanks,
Annette
From: Marius Banica <shpapy AT GMAIL DOT COM>
Subject: Re: NICS AND PROVENTIA G400'S
Its no checkpoint issue
This is due to firmware upgrade of the proventia to 1.3
Please open TAC with ISS support :-)
p.s. I had the same problem.
________________________________
From: Garner, Annette K **BETH
Sent: Tuesday, January 30, 2007 1:08 PM
To: 'FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM'
Subject: NICS AND PROVENTIA G400'S
I am running a firewall on HP DL380 and attached to a Proventia G400 and
I am having trouble getting the nic's to run at 100/FD. When I hard
code them on the Proventia, firewall and switch it causes the nic on the
firewall to go to "no link". When I set it to Auto neg on the firewall
and Proventia it goes to 100/HD. I can not seem to make this work
running a 100/half. I have had the network person set the speed on the
switch to Auto neg and when I hard code everything to 100/FD it shows up
on the switch as 100/HD.
I) I have swapped cables out (both the cross over and straight cable
connection)
2) Changed nics from integrated to Intel Pro/1000 Dual Port
3) changed ports on switch
4) went directly from the firewall to the switch (bypassing Proventia)
and can run at 100/FD.
5) RMA'd the Proventia box - same problem
Spoke with Checkpoint they say its not a problem on the firewall since
it can run at 100/FD when connected directly to the switch.
ISS so far has no suggestions and has not responded.
I was hoping someone else might be running with a Proventia and firewall
and could tell me how they made it work while running at 100/FD.
Thanks,
Annette
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
