Rajeev
Enable Monitor Firewall State: it was disabled in our case - so check it
out
in your Voyager configs.
Monitor FW state was on
Also, do not need Coldstart delay - we removed the interval - it is blank
now (in our case due to some engineer - not sure what is the default
value -
it was set to 300secs).
Coldstart delay was already set to the default blank value
300 secs. ... did you had 3.7 on this box before ... there it wasn't
possible to do fw state monitoring and you needed to work with coldstart
delay.
In 3.8/39 the value disapeared from the gui but if you upgrade to 4.1
your 3.7 value resurfaces.
But I guess 'enabling firewall state monitoring' fixed the issue even
though
we did not test it further by enabling 'coldstart delay'
If had the same issue on a box with coldstart delay and there I could
get it working by turning it of.
On the second cluster which was upgraded from a fresh 3.9 build I can't
get it to work
Ronny
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
| 