Hi,
Is it possible to have Secureclient connecting to a checkpoint gateway that is
behing nat ?
I've configured the nat rules for IKE (udp/500) and FW1_Topo (tcp/264) on the
nat device, translating such traffic to the checkpoint address, but when it
comes to get the topology, checkpoint returns all of its interfaces, but none
corresponds to the one I'm contacting with, wich is a problem.
Is there a workaround ?
Best regards,
Pedro Boavida
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
