Works fine, thx!
> Try the following:
>
> -cpstop
>
> - edit or create (if still not there) the file $FWDIR/conf/discntd.if,
> adding on that file the list of interfaces you don't need to be included in
> the cluster, just add their names (as shown in ifconfig), one by line.
>
> -cpstart
>
> -do the same with every firewall module in the cluster.
>
> Hope this helps.
>
> Regards
>
> On 5/15/07, Markus Schmidt <Markus.Schmidt AT interface-systems DOT de> wrote:
>>
>> Hi everyone,
>>
>> I'm running a Cluster Installation (HA) on R65 with Splat. The machines
>> have 5 Network interfaces, where one of them is part of 2 VLANS.
>> Now my Problem:
>> eth4 is allwasy down, because it is not used. It has no IP assigned, and
>> is not Part of the topology table. Nevertheless, cphaprob states that it
>> causes a problem.
>> Second is the VLAN eth0.2.
>> This gows up and down at will, because the switch, to wich I don't have
>> access, is poorly configured. So I'd like to "don't care" for eth0.2?
>> So is there a way to remove eth4 and eth0.2 from causing a failover?
>> I tried cphaprob -d ethX unregister, but this is not working.
>> Any suggestions?
>>
>> regards Markus
>> --
>> http://schmidt.bs-server.com
>>
>> =================================================
>> To set vacation, Out-Of-Office, or away messages,
>> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
>> in the BODY of the email add:
>> set fw-1-mailinglist nomail
>> =================================================
>> To unsubscribe from this mailing list,
>> please see the instructions at
>> http://www.checkpoint.com/services/mailing.html
>> =================================================
>> If you have any questions on how to change your
>> subscription options, email
>> fw-1-owner AT ts.checkpoint DOT com
>> =================================================
>>
>
>
>
--
http://schmidt.bs-server.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
