You can only use 1 vrid id that contains all of the backup addresses in
simplified mode.
Matt
On Wed, 2007-05-16 at 19:51 +0200, Joel Guillerm wrote:
> We have 2 Nokia with 16 LAN interfaces (IPSO 4.1 + CheckPoint NGX R62) ;
> we used the VRRP simplified method to configure VRRP on both Nokia ;
>
> To test the VRRP failover mechanism, we unplug 1 cable on the VRRP Master
> Nokia, and we can see the associated virtual IP is correctly taken over by
> the backup Nokia, which becomes Master,
> but, the problem is that this 2nd Nokia becomes Master only for this
> interface and remains backup on all the other ones ,
> so, it does not work ;
> we thought the simplified method allowed the failover process to occur on
> all the interfaces at the same time, just when one interface failed on the
> Master Nokia ;
>
> What is wrong on our configuration ?
> we have defined a different VRID for each interface on both Nokias, with
> an associated virtual address for each of them ;
> should we defined a single VRID for all of them with as many virtual IP
> addresses as interfaces on this single VRID ? (not sure it is possible by
> the way)
>
> any help wished
>
> --------------------------------------------------------------------------------------
> Joel
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
