Re: [fw-wiz] Getting OSPF to work on a CISCO ASA 5550

["Keith A. Glass" <salgak@speakeasy.net>]

This is a 5550: no expansion module to start with: two chassis quads.

 

We got a solution over the weekend, basically ignore everything Cisco says in the docs, and three simple lines of code at the command line, rather than ASDMing it.  I’m not the guy who came up with the solution, but I’m implementing it on all our ASA 5550’s. . .

 

Will check, should be publishable, but have to make sure (classified system)

 

From: firewall-wizards-bounces@listserv.icsalabs.com [mailto:firewall-wizards-bounces@listserv.icsalabs.com] On Behalf Of Farrukh Haroon
Sent: Saturday, June 23, 2007 3:45 PM
To: Firewall Wizards Security Mailing List
Subject: Re: [fw-wiz] Getting OSPF to work on a CISCO ASA 5550

 

Keith are you using Transparent mode here?

If so, make sure the two interfaces you use for transparent mode are from the built-in chassis and not from the expansion module.

Try setting p2p non-broadcast OSPF type for troubleshooting purposes (sending unicast msgs instead of multicast)

Regards

Farrukh

On 6/22/07, Keith A. Glass <salgak@speakeasy.net> wrote:

We've been trying, but have had little luck: ADSM config of 2 connecting OSPF routers,  but when we "show ospf nei". . .nothing.

Looking on the switch, OSPF appears to be down. . .


_______________________________________________
firewall-wizards mailing list
firewall-wizards@listserv.icsalabs.com
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards

 

_______________________________________________
firewall-wizards mailing list
firewall-wizards@listserv.icsalabs.com
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards